Carousel advent calendar
A pink, red and navy carousel with 24 numbered drawers until Christmas.
PLA Basic · 350 mm tall · finished by hand
Colour
Printed to order — we confirm your colour with you before printing (call, text or WhatsApp).
From 5 pieces: −10 %
- Delivered in about 8 working days
- Remade at our cost if it arrives damaged
- Secure paymentCardApple PayGoogle Pay
You give your address and pay in one go, on Stripe's secure page.
350 mm tall, next to a 60 mm espresso cup.
The piece
A pink and red striped roof on twisted navy pillars, with a gingerbread man, a bell, a tree and a star hanging from it. At the base, two tiers of round drawers, numbered 01 to 24, each with its own yellow knob.
3D printed in several colours in Lyon, assembled and checked by hand. Decorative: the drawers are made for wrapped chocolates, sweets or small gifts.
Measurements
- Dimensions
- 250 × 250 × 350 mm
- Available materials
- PLA Basic, PLA Matte
- Category
- Advent calendars
Care
- Heat
- PLA softens at about 55 °C. A closed car in full sun goes past that: do not leave the piece in one, not even for an hour.
- Surface
- A matte finish shows fingerprints less, but scratches more easily than a glossy PLA. Keep abrasive sponges away from it.
- Cleaning
- Warm water and a little soap, then dry it. Never in a dishwasher: the heat and the steam warp a printed piece.
Every piece is made in Lyon, to order. The largest we produce in a single piece is 256 × 256 × 256 mm.



