Chimney advent calendar
60€
Santa stuck in the chimney, and 24 brick drawers to open.
PLA Basic · 300 mm tall · finished by hand
Colour
Printed to order — we confirm your colour with you before printing (call, text or WhatsApp).
Quantity
From 5 pieces: −10 %
Total60€
Delivery8 €
- Delivered in about 8 working days
- Remade at our cost if it arrives damaged
- Secure paymentCardApple PayGoogle Pay
You give your address and pay in one go, on Stripe's secure page.
300 mm tall, next to a 60 mm espresso cup.
The piece
An orange brick chimney topped with snow, with Santa's legs and his red sack sticking out of the top. Every brick is a drawer, numbered 1 to 24, with a small gold knob.
3D printed in several colours in Lyon, assembled and checked by hand. Decorative: the drawers are made for wrapped chocolates, sweets or small gifts.
Measurements
- Dimensions
- 240 × 130 × 300 mm
- Available materials
- PLA Basic, PLA Matte
- Category
- Advent calendars
Care
- Heat
- PLA softens at about 55 °C. A closed car in full sun goes past that: do not leave the piece in one, not even for an hour.
- Surface
- A matte finish shows fingerprints less, but scratches more easily than a glossy PLA. Keep abrasive sponges away from it.
- Cleaning
- Warm water and a little soap, then dry it. Never in a dishwasher: the heat and the steam warp a printed piece.
Every piece is made in Lyon, to order. The largest we produce in a single piece is 256 × 256 × 256 mm.



