Made one piece at a time
Manarol is a 3D printing studio. We make to order: pieces from our catalogue, and pieces that exist nowhere else because somebody asked us to create them.
A printed object is neither moulded nor cut from a block. It is built - laid down layer after layer, from the bottom up, until it exists. That is slow and it is precise, and it allows shapes no other technique produces: hollow, articulated, or impossible to release from a mould.
That is also what explains our lead times. A 15 cm figure takes several hours to make, and nobody can shorten them. We would rather give you a true date than a convenient one.
- Manufacture
- To order
- Nothing is produced in batches in advance.
- Quote
- Free
- Sent once we have checked your file.
- Reply
- Within 4 h
- Monday to Saturday, on Instagram and by email.
How it goes
Five steps, from your message to the piece in your hands. You know where your order stands at every moment.
- 01
You ask
A piece from the catalogue, or your own model from a file, from photos, or from a plain description. No account to create.
- 02
We check with you
We write back within 4 hours. This is where we tell you whether the material suits the intended use, whether the size is a problem, or whether another finish would be truer. Often we propose something cheaper.
- 03
We show you
For a piece we model, you see the 3D model before it goes to manufacture. Two rounds of revisions are included. Nothing starts without your agreement.
- 04
We make it
You follow the progress on your tracking page, from first layer to finishing. Every change of stage is notified to you.
- 05
We deliver
To your address, anywhere in Europe and the United Kingdom.
What we can print
Maximum size, layer heights, colours in a single piece, and what each material is actually for are all set out on the pricing page, beside what they cost.
- Maximum size
- 256 × 256 × 256 mm
- In a single piece. Beyond that we cut and assemble.
- Layer height
- 0,08 – 0,28 mm
- A sheet of paper is about 0.10 mm.
- Colours in one piece
- Up to 4
- The colour is in the material: it does not chip off.
- Materials
- PLA, PETG, TPU
- Chosen by use: decorative, everyday, or exposed to heat.
How we work
We say no when it is no
If your piece will not survive its intended use, if the material is the wrong one, or if the deadline is not tenable, we say so before taking the order. A piece that breaks after a week helps nobody.
We never change a price in silence
The displayed price is an automatically calculated estimate. The real price is set once the file has been prepared. If it rises by more than 10%, we ask for your agreement - and you can refuse at no cost, since nothing has been made yet.
Failed prints are ours
A print that fails is run again at our expense, without discussion and without changing your price. If that moves the promised date, you are told the same day.
Your files stay yours
They are used for your order and nothing else. We do not resell them, publish them, or reuse them for another customer.
What we refuse
A machine can make almost anything. We will not.
Cutters, stamps and cake toppers are a different case: they touch dough for a moment, not a meal. We print those in PETG, and they are hand-wash only - never the dishwasher, never left to soak.
- Pieces meant to hold or serve food - plates, cups, containers. The grooves between layers trap bacteria and cannot be cleaned out.
- Weapons, weapon parts, or working replicas of them.
- Copies of objects protected by a copyright or a trademark you do not hold.
A piece in mind?
Send a file, some photos or just a description. We reply within 4 hours, and ship throughout Europe.