Christmas bauble lithophane
Your photograph in a bauble that hangs on the tree and appears in the light.
PLA Basic · 100 mm tall · finished by hand
Colour
Printed to order — we confirm your colour with you before printing (call, text or WhatsApp).
Light
Your photo
A sharp, well-lit, closely cropped photo. We show you the result before printing.
From 5 pieces: −10 %
- Delivered in about 6 working days
- Remade at our cost if it arrives damaged
- Secure paymentCardApple PayGoogle Pay
You give your address and pay in one go, on Stripe's secure page.
100 mm tall, next to a 60 mm espresso cup.
The piece
A photograph becomes a relief: the plastic is thicker where the picture is dark and thinner where it is bright, so light passing through brings the image back.
A bauble to hang on the tree, with your photograph on the front. Unlit, it is a white bauble in relief; lit by the tree lights or a small lamp, the photograph appears.
Add your photograph here as you order. We contact you before printing to show you the result and agree on the lighting. A sharp, well-lit, closely cropped photograph gives the best result; modelling from your image is included in the price.
Measurements
- Dimensions
- 90 × 90 × 100 mm
- Available materials
- PLA Basic, PLA Matte
- Category
- Christmas
Care
- Heat
- PLA softens at about 55 °C. A closed car in full sun goes past that: do not leave the piece in one, not even for an hour.
- Surface
- A matte finish shows fingerprints less, but scratches more easily than a glossy PLA. Keep abrasive sponges away from it.
- Cleaning
- Warm water and a little soap, then dry it. Never in a dishwasher: the heat and the steam warp a printed piece.
Every piece is made in Lyon, to order. The largest we produce in a single piece is 256 × 256 × 256 mm.
