195 mm tall, next to a 60 mm espresso cup.
Personalised lithophane
Your photograph cut into a panel that lights from behind.
PLA Basic · 195 mm tall · finished by hand
Colour
Colour to be agreedNo colour recorded in this material yet. Order anyway: we agree the colour with you before printing. Write to us if you have a particular colour in mind.
Another colour? Tell us: every piece is printed to order.
Quantity
- Estimated material
- 126 g
- Print time
- 12 h 51
Shipped throughout Europe and the United Kingdom. Carriage is worked out in the basket, from the delivery country.
The piece
A photograph becomes a relief: the plastic is thicker where the picture is dark and thinner where it is bright, so light passing through brings the image back.
Heart, rectangle or round, standing on a lit base that runs on batteries or USB. Order here, then send us your photograph on Instagram or from the contact page: we show you the result before anything is printed.
A sharp, well-lit, closely cropped photograph gives the best result. Modelling from your image is included in the price.
Measurements
- Dimensions
- 150 × 110 × 195 mm
- Print time
- 11 h 13
- Available materials
- PLA Basic
- Category
- Gifts
Care
- Heat
- PLA softens at about 55 °C. A closed car in full sun goes past that: do not leave the piece in one, not even for an hour.
- Cleaning
- Warm water and a little soap, then dry it. Never in a dishwasher: the heat and the steam warp a printed piece.
Every piece is made in Lyon, to order. The largest we produce in a single piece is 256 × 256 × 256 mm.