195 mm tall, next to a 60 mm espresso cup.
Skull sweet dispenser
A printed skull that holds the sweets in its jaw.
PLA Basic · 195 mm tall · finished by hand
Colour
Colour to be agreedNo colour recorded in this material yet. Order anyway: we agree the colour with you before printing. Write to us if you have a particular colour in mind.
Another colour? Tell us: every piece is printed to order.
Quantity
- Estimated material
- 243 g
- Print time
- 21 h 35
Shipped throughout Europe and the United Kingdom. Carriage is worked out in the basket, from the delivery country.
The piece
A white skull on a spiderweb base, an orange band across its forehead and its eyes coming out of their sockets. The jaw opens and holds the sweets.
Printed in two colours, assembled and checked by hand. Decorative: it is not made for a dishwasher.
Measurements
- Dimensions
- 100 × 95 × 195 mm
- Print time
- 27 h
- Available materials
- PLA Basic, PLA Matte
- Category
- Home
Care
- Heat
- PLA softens at about 55 °C. A closed car in full sun goes past that: do not leave the piece in one, not even for an hour.
- Surface
- A matte finish shows fingerprints less, but scratches more easily than a glossy PLA. Keep abrasive sponges away from it.
- Cleaning
- Warm water and a little soap, then dry it. Never in a dishwasher: the heat and the steam warp a printed piece.
Every piece is made in Lyon, to order. The largest we produce in a single piece is 256 × 256 × 256 mm.
